earning how to smoke dabs may seem daunting at first, but it’s one of those activities that comes easily once you’ve seen it done. To help ensure your first time goes smoothly, this resource will teach you how to take a dab.

Essentially, dabbing is the flash vaporization of cannabis concentrates once applied to a hot surface and inhaled. These concentrates (you’ve maybe heard of shatter, wax, BHO, oil, etc.) are a lot more potent than flower, so a little bit goes a long way.

While bud tends to test between 15-25% THC, concentrates typically range between 50-80% THC, depending on the extract type and quality. You can even dab non-intoxicating CBD extracts for quick therapeutic effects with little to no cerebral euphoria, but in some regions these oils can be difficult to find.

Dabbing isn’t for everyone, especially if you’re new to cannabis entirely. The dosing process is more delicate, but once you’ve gotten the hang of it, concentrates can offer you new heights of physical relief and unique cerebral effects. Extracts also contain a lot less plant material than flower, so you’re inhaling more cannabinoids (e.g. THC, CBD) and less combusted resin. Check ou our tips for dabbing.

What dab tools are needed?

When learning how to use a dab rig, keep in mind that dabbing technology is evolving. The traditional setup includes the following items (keep in mind that the appearance of each tool may vary slightly depending on its design):

• Dab rig. This is a water pipe is like a bong except it will have a fitting for a nail.
• Nail. This is like the bowl for your bong; where you will put the concentrate. The standard today is a quartz banger, which has a bucket shape. Ceramic and titanium are other options, and e-nails are becoming more common. Be sure to get the correct joint (where the nail slides into the dab rig) size: If your rig has a 14mm stem, you need a 14mm nail. Nails can be male and female as well—you need a male nail for a female rig, and vice versa.
• Dabber. Use this tool to apply the dab to the nail. They can be metal, glass, or ceramic, and have many shapes: ballpoint, needlepoint, scoop, spoon, paddle, etc. Pick a shape depending on the texture and consistency of the concentrate you’re dabbing.
• Carb cap. Although not necessary, we highly recommend one of these to help regulate airflow. Combination dabber/carb caps are increasingly popular. Always cap your dabs.
• Torch. Mini-torches used for crème brulee are common used, but you’ll have to stock up on propane for them. Again, e-nails are increasingly common (but expensive) and cut out the need for a torch.
• Cannabis extract. These come in a variety of forms, but the most common ones used for dabbing are BHO, CO2, and solventless extracts like rosin. Don’t dab with alcohol-based extracts, and if you have any doubt at all about the safety of dabbing a particular oil, ask your budtender.
• (Optional): Dab mat. To keep your dabbing surface clean and not sticky.
• (Optional): Timer. To ensure you heat your nail up consistently for each dab.

How much oil is enough to dab?

Different extracts have different THC concentrations, so it’s helpful to know how potent your oil is before dabbing with it. However, it’s generally recommended to start small and increase the dose if you feel comfortable doing so.

A small dose is no bigger than a crumb. It may not look like much, but that’s still a lot of THC going straight to the dome at once. Dabbing can feel a lot more intense to those accustomed to flower, but as your tolerance adjusts, the effects become less jarring.

How do you dab?

Once the rig is set up and your dab is prepared on the dabber, you’re ready to get started. We advise you to sit while taking a dab, since the rush of THC can be physically intense.

• Step 1: Turn on your torch and aim the flame directly at the nail. Most people will heat the nail until it begins turning red-hot. If you’re using an electronic nail, refer to the section below for more information on heating.
• Step 2: Once the nail is hot, turn off your torch and place the glass dome over the nail. It’s recommended to let titanium nails cool for about 10 seconds and quartz nails about 45 seconds so the surface temperature isn’t too hot. Refer to this article to learn more about the importance of low-temperature dabbing).
• Step 3: Take your dabber, apply the dab directly on the nail inside the dome, and inhale slowly. Rotating the dabber tip on the nail can help you prevent wasting any oil stuck to the dabber.
• Step 4: Exhale and enjoy!

Safety notice: nails and glass domes become extremely hot in the dabbing process. Take caution when handling them, and always wait for all pieces to cool down before you even think of touching them.

How to clean your nail

After a dab, carbon, reclaimed oil, and particulates can build up in the nail. A lot of people will clean their nail after each hit, but you should at least do it at the end of each session. Here are some ways to clean your nail:

• Torch. The easiest way to clean your dab nail is to heat it with your torch to burn off any residual carbon or reclaim on your nail. When applying this method to ceramic and quartz nails, be careful not to expose your red hot nail to a rapid change in temperature or you may risk a stress fracture. After your nail becomes red hot and the residue dissipates, let it cool down completely before finishing off with a final scrape.
• Scrape. For minor buildup, use a sharp dabber tool to lightly scrape your nail. Be careful not to chip any glass.
• Wash. Try soaking your nail in 91% isopropyl alcohol for 10 minutes.

What are e-nails and domeless nails?

The above tutorial explains how you take a dab using the common torch-and-nail method, but there are other dabbing attachments that deviate slightly from this process.

Domeless nails are metal pieces that don’t require a glass hood to trap vapor. Instead, a network of holes throughout the nail deliver the vapor straight through the piece. You still heat it as you would a standard nail — the advantage is not having to hassle with an extra glass piece that can become hazardous with heat and sticky with resin.

E-nails, or electronic nails, are significantly more expensive than standard and domeless nails, but the investment is often worth it for serious dabbers. They cut out the need for a dome as well as a torch, which is easily the most dangerous element of dabbing. Furthermore, you have full control over your nail’s temperature. This is a fantastic feature if you care about making the most out of flavors and terpenes when you dab.

Dabbing technology is constantly improving and expanding, so be sure to check out other Leafly articles diving into the latest trends and products if you’re interested in leveling up your dabbing game!

This post was originally published on December 9, 2015. It was most recently updated on June 26, 2020.

Bailey Rahn

Bailey is a senior content manager at Leafly, specializing in strains and health. She’s spent 7+ years researching cannabis products, spreading patients’ stories, and exploring healthy ways of integrating cannabis into daily life.